At this stage it is important to continually try on the helmet to make sure everything fits correctly, it's much easier to fix at this stage than later. I again used strips around the same size and made sure to bend them to the curvature of the basic helmet shape. Once this basic "skeleton" is created all that is left is to fill the remaining spaces with cardboard. After this is is done, use more strips to join the top half to the bottom circle. Next we will make another circle, this time fitting around the bottom of your head around the jaw, again leaving enough room to wear comfortably. This creates the curvature of the top of your helmet. Next use the strips to run from the middle of the forehead piece to the back. Use two of these strips to create a circle around your forehead with enough room to spare to fit comfortably and hot glue them together. To do this first we cut strips of cardboard about an 1.5" tall and 14" in length. The first step is to create the basic shape of the helmet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |